







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Unilock Driveway & Pavers: The Summerlin Owner’s Guide
We install Unilock pavers and Unilock-compatible driveway systems across Summerlin, and a full paver driveway typically runs $7,000 to $18,000 installed. Repair and reset work on an existing Unilock driveway often lands far below that, so the first step is an honest assessment of what’s actually failed. Bradford Remodeling Co Summerlin is an independent service provider and is not affiliated with Unilock.

Most Summerlin homeowners find out something is wrong the same way: a paver lifts slightly under a foot near the driveway apron, or a joint line that was tight last spring now reads a half-inch wide by August. Sometimes it’s a single cracked unit at the garage transition where the slab meets the field. Sometimes it’s a whole corner of the drive that’s dropped and starts puddling after monsoon rain. By the time you’re noticing it, the cause is usually underneath the surface, not in the pavers themselves.
Which Unilock Models This Applies To

Unilock makes several paver lines commonly used on residential driveways in Summerlin, including Brussels Block, Brussel’s Dimensional, Hollandstone, and the Estate Wall and Thornbury lines used at driveway borders and entrance piers. Each line has its own nominal thickness and face dimensions, and those dimensions matter when you’re matching replacement units against an existing field. Brussels Block, for example, is a tumbled 60mm paver with a characteristically irregular edge; a smooth 60mm paver set into that field will read as a patch from twenty feet away because the edge profile doesn’t match.
To identify what you have, look for a manufacturer stamp or a printed code on the underside of a lifted or broken unit (Unilock pavers typically carry a mark), measure the face dimensions in millimeters, and note the thickness. Thickness is the one most homeowners skip, and it’s the one that causes the most callbacks. A paver that’s 10mm thinner than the surrounding field will rock and settle differently no matter how well it’s bedded. Where the original line is discontinued or a dye lot has shifted, the honest answer is often to reset a full course rather than chase a single replacement unit. On OEM-versus-aftermarket: for Unilock field pavers, matching the original Unilock line is almost always the right call. For bedding sand, polymeric joint sand, edging, and base aggregate, a quality equivalent is fine and we’ll tell you plainly where the substitution is invisible and where it isn’t.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Unilock Driveway & Pavers Is Failing
- Paver lippage (a raised edge you catch a shoe on). Untrained eyes read this as a bad paver. It’s almost always base settlement or a failed bedding layer, and the paver itself is fine and reusable.
- Widening joints or sand washing out. Polymeric joint sand has a real service life in Southern Nevada’s heat and UV load, and once it breaks down the joints open and the interlock loosens. Refilling without fixing the cause just repeats the cycle.
- Cracked or spalled units, especially at the apron and garage transition. These are the points where the paver field meets a rigid concrete slab. Thermal movement concentrates there, and a paver set tight against concrete with no movement joint will crack within a season or two.
- Ponding after rain or irrigation runoff. A low spot in the drive means the base has settled or the original slope was never set correctly. Water sitting on a paver drive finds its way into the joints and into the base, and it accelerates everything else on this list.
- Edges spreading or the border units walking outward. Edge restraint has failed or was never deep enough. Pavers only hold their pattern because the edge is locked, and once the border creeps the whole field loosens from the perimeter inward.
Replacement Cost & What’s Included

Here’s what pavement work typically costs in Summerlin, and every one of these is a written price before work starts:
| Scope | Installed Price Range |
|---|---|
| Paver driveway installation (Unilock or compatible) | $7,000 – $18,000 |
| Paver patio installation | $3,500 – $11,000 |
| Driveway replacement (full tear-out and rebuild) | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
What drives the number up or down: driveway square footage, how much base has to be excavated, whether the existing base can be re-compacted or has to be replaced, the specific Unilock line (premium lines with borders and tumbled faces cost more than a plain field), and access for equipment. A single-course repair near the apron sits at the low end. A full drive with a new compacted base, edge restraint, and polymeric joint sand sits at the top. All completed work is covered by our 365-Day Done Right Promise: if the work fails within one year, we come back and correct it at no charge, and that guarantee is in your hand in writing at job close.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
You can safely check a few things yourself. Lift a loose unit and look for the manufacturer mark and measure its thickness. Check whether joint sand is missing or compacted hard. Walk the drive after rain and note where water pools. Those observations shorten the estimate and save you money.
Where DIY goes wrong on paver work is the base. A paver driveway is only as good as the compacted aggregate base under it, and that base is typically 4 to 6 inches of graded, plate-compacted material in layers. Getting it right requires a plate compactor and a straight edge and a lot of patience, and doing it wrong means the new surface settles in exactly the way the old one did. Pulling up and resetting a whole course also needs the right edge restraint depth and a movement joint where pavers meet concrete. That’s the part where we’d rather see your driveway than hear about it later. Call (844) 588-0072 and we’ll come look.
FAQs

A properly installed Unilock paver driveway with a good compacted base realistically lasts 25 to 30 years or more. The pavers themselves are the durable part. What fails first in Southern Nevada is the joint sand and the base, driven by heat cycling and irrigation runoff, not the pavers.
Yes, and often it should be. A single course reset, new polymeric joint sand, or a re-leveled low spot is far cheaper than a full replacement and handles most of the failures we see. Call (844) 588-0072 for an exact quote and we’ll tell you which side of that line your drive is on.
A course repair or re-sanding is typically a one-day job; a full driveway tear-out and rebuild usually runs three to five days depending on square footage and base conditions. You’ll have the schedule in writing before we start.
We identify your Unilock line from the stamp and measurements, then source through the manufacturer’s supplier network, matching line, face dimensions, thickness, and dye lot wherever possible. Where a line is discontinued, we’ll tell you that plainly and propose a reset course or a visible border transition rather than an invisible mismatch.
We also install and match KraftMaid, Cambria, and Silestone on the interior side of the same properties.
Get a Written Price for Your Summerlin Driveway
If your Unilock driveway is showing lippage, washed-out joints, or ponding, we’ll come out, identify the actual cause, and put a real number in writing before any tool comes out. Bradford Remodeling Co Summerlin works to The Garrison Standard, which means a documented scope, a written price, and the 365-Day Done Right Promise on every completed job. A live person answers the phone, day or night. Call (844) 588-0072 for a free estimate.
Written by the team at Bradford Remodeling Co Summerlin, serving Summerlin and nearby areas.












