







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Therma-Tru Driveway & Pavers: The Summerlin Owner’s Guide
A Therma-Tru-compatible paver driveway or entry paver system in Summerlin runs $7,000 – $18,000 installed, and most single failing sections we’re called out for can be quoted and scheduled within the same week. We install the paver and hardscape work that pairs with a Therma-Tru entry system – the walkway, landing, and driveway apron that a Therma-Tru door opens onto – and we price it in writing before anyone picks up a tool. Homeowners usually catch the problem the same way: a paver lifts at the threshold after a hard rain, a hairline crack spreads across the landing slab, or the door starts dragging because the ground under it has shifted.

One note up front: Bradford Remodeling Co Summerlin is an independent service provider. We’re not affiliated with Therma-Tru, and we don’t speak for the manufacturer. What we do is install and correct the hardscape around a Therma-Tru entry so the door and the ground it sits on work together, with a written price and the 365-Day Done Right Promise behind the work.
Which Therma-Tru Models This Applies To

Therma-Tru entry doors – the Fiber-Classic, Smooth-Star, and Classic-Craft lines, plus the sidelight and transom configurations that often come with them – all share one thing at the threshold: a sill that needs a stable, correctly sloped hardscape surface beneath it. That’s where the paver work meets the door. The door model itself doesn’t change the driveway, but the entry configuration does. A Fiber-Classic with full sidelights and a transom has a wider, heavier landing footprint than a single 36-inch door, and the paver apron and step-down need to be built for that load.
Here’s the compatibility detail most homeowners miss: Therma-Tru sill heights and threshold profiles vary by line, and the paver landing has to be set so the finished exterior grade sits roughly 1 to 1.5 inches below the sill. Too high and water wicks under the door; too low and you’re stepping down farther than the door was built for. We measure the actual threshold, not guess at it. The same logic runs through kitchens and baths we do on the same homes, where we’re specifying KraftMaid and Cambria alongside the hardscape, so tolerances get checked once and documented, not eyeballed on three separate visits.
On OEM versus aftermarket for the hardscape: Therma-Tru makes doors, not pavers. The paver, base, and edge restraint come from hardscape manufacturers whose specs we carry. If a supplier tells you a paver is “Therma-Tru-approved,” treat that as marketing, not a real standard – match the paver to the load and the climate, and match the door to its threshold.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Therma-Tru Driveway & Pavers Is Failing
- Pavers settling or rocking at the threshold. The base course has lost compaction or the soil beneath it has shifted, usually from water finding a low spot. A rocking paver lets water straight into the door’s sill zone.
- A crack spreading across the landing or apron slab. Summerlin’s shrink-swell soils and wide day-to-night temperature swings work a slab hard. A crack that starts near the door and runs out is telling you the sub-base moved, not that the concrete is bad.
- Efflorescence – the white chalky bloom – on pavers or concrete. That’s mineral salt drawn up by moisture from underneath. It means water is getting in and staying there, which is the same water that eventually reaches your Therma-Tru sill.
- Standing water or a puddle that lingers after rain. The surface has lost its slope toward the drain or street. Flat water against an entry door is the single most common cause of a rotting or warping sill we’re called out to correct.
- Ponding at the door and a door that drags or sticks. When the ground heaves and the landing rises, the Therma-Tru slab or threshold gets out of square and the door starts catching. This one is a hardscape problem, not a door problem, even though the door takes the blame.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what the work actually costs in Summerlin, based on the same market-calibrated ranges we quote citywide:
| Work | Installed Range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Concrete driveway installation | $4,500 – $12,000 |
| Driveway replacement | $5,000 – $14,000 |
| Paver patio installation (entry/landing area) | $3,500 – $11,000 |
| Driveway sealing | $250 – $700 |
What drives the range: square footage, whether the base has to be torn out and recompacted, the paver or slab type, and drainage correction. Your written price quotes the base prep, the paver or slab, the edge restraint, and haul-off as separate line items, so you see exactly what you’re paying for. Because we work from a documented roster of name-brand materials – Belgard and Unilock pavers among them – specifications come with manufacturer warranties on top of our own. Every completed job is covered by the 365-Day Done Right Promise: if the work fails inside that window, we come back and correct it at no charge.
DIY or Call Us?
Some things you can check safely yourself: look for rocking pavers, note where water pools after a Summerlin monsoon, and confirm the surface still slopes away from the door. Sealing a sound driveway is a reasonable weekend project.
Where DIY goes wrong is the base. Rebuilding a settling paver apron or replacing a cracked slab means knowing the compaction depth, the slope, and how the finished grade sits against your Therma-Tru threshold – get it wrong and you’ve moved the water problem under the door. That’s heavy, technical work, and it’s not the place to learn by trial. We’ll handle the base, the slope, and the threshold measurement in one pass. Call (844) 588-0072 to schedule a free estimate – the price you get is written before any work starts, and a live person answers day or night.
FAQs

A properly installed paver driveway lasts 25 to 50 years in Summerlin’s climate, and concrete typically runs 20 to 30 years before cracking becomes a problem. The variable isn’t the material – it’s the base compaction and drainage, which is where our work starts. Call (844) 588-0072 for an exact quote – estimates are free.
Yes, in many cases. A single settling paver apron or one cracked slab can often be lifted, re-based, and reset for a fraction of a full replacement. We’ll tell you in writing whether a repair will hold or whether the base is too far gone. Call (844) 588-0072 and we’ll give you a straight answer.
A paver landing or entry apron is usually a small-job timeline measured in days, while a full driveway replacement runs longer depending on square footage and base work. We confirm the schedule in writing alongside the price before the crew arrives. Call (844) 588-0072 to book a free estimate.
We install from a documented roster of name-brand hardscape manufacturers, including Belgard and Unilock, so every spec is traceable and carries its own manufacturer warranty. Your written quote names the exact product and finish. Call (844) 588-0072 for a free estimate.
We also service KraftMaid, Cambria, and Silestone on the same homes, so a single documented visit can cover more than one surface.
Written by the team at Bradford Remodeling Co Summerlin, serving Summerlin and nearby areas.












