







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Schluter Fence Installation: The Summerlin Owner’s Guide
We install and replace Schluter-compatible fence systems in Summerlin, and most full installations land between $3,500 and $9,000 depending on fence length, material, and gate count. If you have a failing section, we can often get a technician out to assess it the same day you call. Homeowners here usually discover the problem the same way: a gate that drags two inches lower than it did last spring, a post that rocks when they lean on it, or a stretch of fence that dips after a monsoon gust or a hard irrigation cycle pushes water against the footings. By the time the sag is visible from the street, the failure has usually been working for a season or two.

Which Schluter Models This Applies To

Schluter is best known in the trade for tile and substrate systems, and that matters when a homeowner says “Schluter fence.” What we see in Summerlin is almost always Schluter’s edge-protection and transition profiles adapted as trim and cap detail on fence panels, gate surrounds, and decorative screening, not a freestanding Schluter fence line. Identifying the right part starts with the profile itself: measure the overall height and the reveal (the visible face width), then match the stamped series marking on the back of the profile. Schluter profiles come in nominal sizes that step in small increments, so a 3/8-inch profile and a 1/2-inch profile look nearly identical on the fence until you measure. Skipping that measurement is the most common compatibility error we correct.
On the OEM-versus-aftermarket question, Schluter’s own profiles carry published tolerances that generic trim stock does not. For exposed Summerlin sun, that tolerance matters: an under-spec substitute can bow within a season. Bradford Remodeling Co Summerlin is an independent service provider, not affiliated with Schluter, and we’ll tell you straight when the OEM part is worth the premium and when a quality equivalent will hold. We can also source matching detail on KraftMaid, Cambria, and Silestone finishes if your fence ties into those surfaces.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Schluter Fence Installation Is Failing
- Sagging gate or panel at the hinge side. The fasteners have lost bite in the substrate or the post has shifted. Once a gate drops, the profile is taking load it was never meant to carry.
- Loose or spinning fasteners. Screws that won’t tighten mean stripped substrate or water sitting in the post. That’s the early stage of a much bigger repair.
- Rust streaks or white oxidation at the profile edge. Summerlin’s dry air hides corrosion until it’s advanced; irrigation overspray accelerates it on the shaded side of the fence.
- Visible gap between profile and panel. A gap means movement or settled footing. Left alone, water gets behind the trim and the panel starts to delaminate.
- Post that rocks under hand pressure. The concrete footing has cracked or the soil has shifted. This one is structural, not cosmetic, and it will not fix itself.
Replacement Cost & What’s Included
Installed replacement and repair work for Schluter-compatible fence systems in Summerlin runs $3,500 to $9,000 for a full installation. The range is driven by fence run length, material, gate count, and whether footings need re-pouring. A profile-only swap sits at the low end; a full run with new posts and footings sits at the high end. Every price is written before any work starts, with parts and labor itemized, so there are no numbers that move at the door.
What’s included: removal of the failed section, substrate inspection, re-pour of compromised footings, installation of the matched profile, and a clean site at close. Every completed job carries our 365-Day Done Right Promise – a written full-year guarantee. If the work fails inside that window, we come back and correct it at no charge.

See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
You can safely check the fence yourself: walk the run and push on each post, run a screwdriver across the fasteners to feel for spin, and measure the profile height and reveal so you have numbers when you call. That’s the useful homework. What goes wrong with DIY is the post footing and the profile load path. A post that rocks means concrete work, and a mis-set profile on a shifted post will fail again within a season. We’d rather you not spend a weekend on it and call us anyway. Technicians here have up to 22 years of experience, and they’re background-checked and uniformed. Call (844) 588-0072 and a live person will pick up, day or night, to get your profile measured and your price written.
FAQs

How long does a Schluter fence installation last in Summerlin? Most well-installed runs hold 15 to 20 years, but Summerlin’s sun and irrigation exposure shorten that on the west-facing side. UV and moisture cycling are the two things that age the profile and the substrate fastest. Call (844) 588-0072 for an exact assessment of your run.
Can it be repaired instead of replaced? Often yes. A single failed profile or a loose gate can usually be repaired without touching the rest of the run. The call is whether the substrate and footings are still sound; if they are, a repair is the honest answer.
How long does the swap take? A profile-only repair is typically a single-day job. A full run replacement with new footings usually takes two to three days depending on length and gate count. You’ll get a written schedule with the written price.
How do you source the part? We match the part to your profile’s measured height, reveal, and stamped series marking, then confirm the OEM or equivalent spec before ordering. No guessing at the door, and the spec is documented on your written quote.
Get Your Fence Squared Away
If your Schluter-compatible fence in Summerlin has a sagging gate, a rocking post, or a profile that’s pulling away, call (844) 588-0072 for a free estimate. We’ll measure the part, write the price before we touch a tool, and stand behind the work for a full year under the 365-Day Done Right Promise. Every project runs on The Garrison Standard: written scope, documented materials, background-checked technicians, and a clean site when we’re done.
Written by the team at Bradford Remodeling Co Summerlin, serving Summerlin and nearby areas.












