







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Quikrete Driveway & Pavers: The Summerlin Owner’s Guide
If your Quikrete product has a failing component and you’re in Summerlin, you’re looking at a repair or replacement rather than a full rebuild in most cases. A paver driveway install runs $7,000 – $18,000 here, a concrete driveway $4,500 – $12,000, and most small repairs, re-leveling or re-setting work comes in well under that. We’re an independent contractor, not affiliated with Quikrete; we install and repair Quikrete-compatible products across Summerlin and the surrounding valley.

Most owners discover the problem the same way: a half-inch lip appears where two pavers meet and stays there after a good sweep, or a hairline crack in a concrete slab starts catching your hose. Left alone through a Summerlin summer, that small fault spreads. UV index in the valley runs high most of the year, and the ground moves from dry shrink to monsoon swell, which is a hard combination on any finished surface.
Which Quikrete Models This Applies To

Quikrete products that land on a driveway or paver surface in Summerlin fall into a few practical categories, and knowing which one you have tells us how to approach the fix:
- Concrete mixes (Concrete Mix, High Strength Concrete Mix, Crack-Resistant Concrete) – the base material for poured driveways and slab repairs. Bag weight and yield matter more than the name; a 60 lb bag yields roughly half a cubic foot, an 80 lb bag closer to two-thirds.
- Paver joint and setting materials – the sand and joint compounds that lock pavers in place. These fail differently from concrete.
- Patches and toppings – Concrete Patch, Vinyl Concrete Patcher and similar. Good for small faults, not for structural cracks.
- Sealers and hardeners – the surface protectant layer, which takes a consistent beating in desert sun.
The compatibility gotcha most homeowners miss: Quikrete joint and setting materials are matched to paver thickness and joint width, and the wrong grade in a Summerlin driveway shows up as joint sand washing out within one monsoon season. The label has the joint-width spec; measure your joints before you buy. If you’re deciding between an OEM-spec Quikrete product and a comparable aftermarket equivalent, both can work, but the aftermarket needs to state the same joint width and load rating or it won’t hold in a drive lane. That spec match, more than brand loyalty, is what keeps the surface tight.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Quikrete Driveway & Pavers Is Failing
- Pavers that rock or wobble underfoot. The setting bed or joint material has lost its grip. Common in Summerlin after a wet winter followed by a dry spring; the base underneath has shifted and the paver no longer sits flat.
- Lip between adjacent pavers or slab panels. One side has settled, usually because water is getting underneath and eroding the base. A lip that’s growing is the sign the problem is still active.
- Joint sand washing out in streaks. Either the wrong joint grade was used or drainage is pushing water across the surface instead of off it. In Summerlin’s brief but intense monsoon storms, a joint that drains poorly will empty within a season.
- Hairline cracks spreading across a concrete slab. Usually a mix-or-cure issue rather than the material failing on its own. Cracks wider than a credit card need more than patch compound.
- Chalking or powdering on the surface of a sealed or hardened driveway. The sealer layer is breaking down from sun exposure. Cosmetic on its own, but it lets moisture into the slab or paver joint and shortens the life of the base.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what Quikrete driveway and paver work runs in Summerlin, installed and given as a written price before we start:
- Paver driveway installation: $7,000 – $18,000
- Concrete driveway installation: $4,500 – $12,000
- Driveway replacement: $5,000 – $14,000
- Driveway sealing: $250 – $700
- Paver patio installation: $3,500 – $11,000
What drives the range: square footage, base prep (a proper compacted base is the single biggest cost variable), paver thickness or slab depth, and whether the existing surface needs to come out. Parts-plus-labor is broken out line by line in your quote, so you see the material cost and the labor separately. Every job we complete carries the 365-Day Done Right Promise, a full-year written guarantee; if the surface fails inside that window, we come back and correct it at no charge.

DIY or Call Us?
You can safely check your own situation before calling anyone. Walk the driveway after a rain and look for low spots where water pools. Measure the lip between pavers with a ruler. Probe a rock with your hand to see if the base below has washed out. Those three checks tell us a lot about what we’re dealing with. We install Quikrete-compatible materials, and here’s the honest safety note: grinding, cutting or lifting a slab, or tearing out a paver base by hand, is hard physical work with real injury risk and typically needs equipment most homeowners don’t own. You also have the base compaction question, which is where most DIY driveway failures start. For anything beyond a sand refill or surface patch, we recommend a trained crew do the work. Call (844) 588-0072 for a free estimate; the number is answered by a live person, not a queue.
FAQs

A properly base-prepped Quikrete-compatible paver driveway in Summerlin typically holds 20-plus years, and a concrete driveway 25 to 30 years, but the base prep drives that more than the material. The desert sun and yearly ground movement shorten the life of any driveway that wasn’t compacted correctly. If yours is under 10 years old and already cracking or rocking, base issues are the likely cause. Call (844) 588-0072 for a free estimate and we’ll tell you what we see; there’s no cost to look.
Usually yes, and it’s worth checking before you commit to replacement. Re-setting loosened pavers, refilling joints with the correct grade and sealing a concrete slab run well under the cost of a new install, in the $250 – $700 range for sealing and more for paver re-setting depending on square footage. What can’t be patched is a base that has failed underneath. Call (844) 588-0072 for a free estimate and we’ll tell you straight whether it’s a repair or a full replacement.
A sealing or joint refill job runs a single day. Re-setting pavers or patching concrete is one to two days. A full driveway replacement takes three to five days depending on square footage and base prep, and we schedule the work around weather because a Summerlin monsoon afternoon can shut a pour down. Call (844) 588-0072 to schedule your free estimate and we’ll give you the exact timeline in the written quote.
We source Quikrete products through established building material suppliers in the valley, matched to your driveway’s spec: concrete mix grade for slabs, or joint and setting material grade for pavers. We don’t stock material ourselves; it comes in per job, and the spec is confirmed before we order. Everything is documented in your written quote, including the exact product used and the quantity. Call (844) 588-0072 for a free estimate.
If you have a failing Quikrete driveway or paver surface, call (844) 588-0072 to schedule your free estimate. We’ll walk the driveway with you, explain what’s failing in plain language, and give you a written price before any work starts. Bradford Remodeling Co Summerlin also installs KraftMaid, Cambria and Silestone products as part of our broader remodeling work, and every project carries the 365-Day Done Right Promise. Our technicians have up to 22 years of experience, they’re background-checked, and the number is answered by a live person, any time.
Written by the team at Bradford Remodeling Co Summerlin, serving Summerlin and nearby areas.












