







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cambridge Pavers Fence Installation: The Summerlin Owner’s Guide
Fence installation over Cambridge Pavers hardscape in Summerlin typically runs $3,500 – $9,000 for the full project, and we schedule these as planned work – estimates are free and the written price is fixed before any material is ordered. If your Cambridge Pavers retaining wall, pier base or column footing is what the fence ties into, the failure usually shows up as a leaning post, a hairline split at the pier cap, or a fence line that has started to rack since the last monsoon season. Summerlin homeowners most often notice it after a wind event, when a gate stops latching clean.

We’re an independent installer, not affiliated with Cambridge Pavers, and we work with whatever Cambridge Paver system is already on your property.
Key Takeaways
- Full Cambridge Pavers-compatible fence installation in Summerlin: $3,500 – $9,000 installed.
- Failing pier caps, leaning posts and racked panels trace back to footing and substrate problems more often than to the fence itself.
- Written price before work starts, every project, no change orders at the door.
- Every completed job carries the 365-Day Done Right Promise – if the work fails inside that window, we come back and correct it at no charge.
Which Cambridge Pavers Models This Applies To

Cambridge Pavers builds its systems around modular units – the Cambridge Pavingstones line, the Wallstone retaining wall units, and the pier and column kits that many Summerlin properties use to anchor a fence run or a gate post. Compatibility questions come down to three measurements: the nominal face width of the unit your pier is built from, the cap thickness, and the footing depth below grade. Two properties on the same Summerlin street can carry different pier kits, so we take the three measurements on-site rather than assume from the street name.
Identify your system by looking at the pier cap underside for a molded stamp, then measure the face of one full unit. Cambridge units usually run in the 6 – 8 inch face range, but the cap and coping profiles vary by series, and mixing a cap from one series onto a wall from another is the most common compatibility miss we correct. On the OEM-versus-aftermarket call: for the paver units, caps and coping we use Cambridge-spec or quality equivalents that match the profile and load rating, and we say which you’re getting in the written scope. For the fence posts, rails and hardware, the metal is the metal – we spec to your fence style and the paver system it ties into. We don’t claim to stock Cambridge Pavers parts or carry them on a truck; every part is sourced against your measurements and confirmed before we cut anything. Homeowners sometimes ask us to coordinate the hardscape side with kitchen and bath brands we also work with like KraftMaid, Cambria and Silestone – same written-scope discipline applies.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Cambridge Pavers Fence Installation Is Failing
Failures in Summerlin tend to follow the climate. The desert swings from 110°F afternoons to 40°F nights, and the soil under a paver pier moves with that cycle, which is why most problems show at the base before they show in the fence.
- Post leaning out of the pier. The footing has shifted or the post anchor has worked loose from the pier core. Underlying cause: shallow footing or a pier built without a proper concrete core.
- Hairline crack across the pier cap. Thermal movement on a cap that was set with too little bed joint. Left alone, water gets under the cap and the crack widens each season.
- Fence line racking after wind. Rails have pulled from the post pockets because the post base is no longer plumb. Cause: a single failed anchor in the run, not the whole fence.
- Gate dragging or failing to latch. The pier on the hinge side has settled a fraction of an inch, which throws the gate geometry off. Cause: footing bearing on loose native soil.
- Efflorescence and spalling on the pier face. Salt bloom and surface flaking on Cambridge units where water is trapping against the fence post. Cause: missing drainage at the post base.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Cambridge Pavers-compatible fence installation in Summerlin runs $3,500 – $9,000 installed. That range covers removal of the failed section, footing and pier correction, post and rail install, gate hang and hardware, and clean-up. What drives you toward the top: pier rebuilds, gate return sections, linear footage beyond a standard side-yard run, and matching a discontinued cap profile. What keeps jobs near the bottom: a straight reinstall over sound piers with standard hardware.

Our written scope separates parts and labor so you can see what the pier work costs versus the fence. Every completed project is covered by the 365-Day Done Right Promise – a full-year written guarantee, and if the work fails inside that window we return and correct it at no charge. Live person answers the phone 24/7, and the price you see at the estimate is the price on the invoice.
DIY or Call Us?
You can safely measure the pier face, note the cap thickness, photograph the molded stamp on the cap underside, and check whether a post is plumb with a four-foot level. Stop there. Pier rebuilds involve cutting out a concrete core, resetting a footing in desert soil, and re-anchoring a post that carries real wind load – done wrong, the fix fails within a season, and a gate can swing or drop on someone. Pulling a cap to “see what’s under it” often cracks it and turns a $150 part into a full pier rebuild.
The honest split: measure and photograph, then let us assess. We’ll give you a written price for the correct fix, and if the pier is sound and only the anchor is bad, we’ll tell you that instead of selling you a rebuild. Call (844) 588-0072 to schedule your free estimate.
FAQs

A properly built installation should hold 15 – 20 years for the paver and pier work and 8 – 12 years for standard metal fence components, though Summerlin’s heat and soil movement shorten that if the footing is shallow. The pier footing, not the fence, is the deciding factor.
Often yes. A single failed post anchor or a cracked cap can be repaired without touching the rest of the run, and we’ll price the repair first if it’s the safer call. We only recommend replacement when the footing or the pier core has failed.
A repair runs one day; a full side-yard installation typically takes 2 – 4 days depending on pier work and gate sections. Your written scope states the schedule before we start.
We measure your existing Cambridge unit, match the profile and load rating, and confirm sourcing before we order – nothing is guessed. Call (844) 588-0072 for an exact quote; estimates are free.
Written by the team at Bradford Remodeling Co Summerlin, serving Summerlin and nearby areas.












