







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Barrette Driveway & Pavers: The Summerlin Owner’s Guide
We install and replace Barrette driveway and paver systems across Summerlin, and a full paver driveway runs $7,000 to $18,000 installed, with paver patios at $3,500 to $11,000. Because this is planned hardscape work, expect a scheduled installation rather than a same-day fix; we give you a written price before any work starts and put the schedule in writing too. Bradford Remodeling Co Summerlin is an independent service provider and is not affiliated with Barrette.

Summerlin owners usually spot the problem the same way. A paver near the driveway apron rocks underfoot when the desert sun hits it. Joint sand washes out after a monsoon and the field starts shifting. Or a hairline crack opens along a border course and a corner piece lifts free of the base. That lifting corner is the tell: the failure is almost never the paver itself, it’s the substrate and edge restraint beneath it, and that’s the part that has to be rebuilt right.
Which Barrette Models This Applies To

Barrette’s paver lines fall into distinct families, and matching the right replacement means knowing which one sits in your driveway. The structural slab pavers (their thicker profile, commonly 60mm and up) belong on driveways and aprons that take vehicle load. The thinner 60mm-or-under units and the plank-style and textured lines are meant for patios, walkways, and pool decks. Using a patio-grade unit in a driveway is a compatibility gotcha we fix regularly in Summerlin: it looks fine for a season, then the field ruts where tires track.
To identify yours, pull the original contractor’s submittal or a leftover paver from a corner. Measure the thickness with a tape (60mm reads just under 2-3/8 inches; 80mm nearer 3-1/8 inches), note the face texture and color name, and check the edge profile. Barrette’s systems also depend on matched polymeric joint sand and an edge restraint; a replacement paver from a different maker with a slightly different height will telegraph through the whole field.
OEM vs. aftermarket for Barrette
For a small repair, a genuine Barrette unit in the right series and color is the clean answer because the dimensions and face match the surrounding field. A quality aftermarket paver works when the color line is discontinued or the run is hidden at a border, but you accept a small variation in tone and thickness. We tell you which path we’re taking and why, in the written price, before a single unit is set. We also source KraftMaid, Cambria, and Silestone for the interiors side when a hardscape job turns into a patio-and-outdoor-kitchen project.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Barrette Driveway & Pavers Is Failing
- Rocking or loose pavers. The units have lost their bedding sand or the base beneath settled. One loose paver usually means the surrounding field is compromised too.
- Joint sand washing out. Summerlin’s monsoon bursts scour the joints faster than the original sand can hold. Once the sand is gone, water gets under the units and the field spreads.
- Rutting in the wheel path. This points to an undersized base or a patio-grade paver taking vehicle load it wasn’t built for. It gets worse each summer.
- Lifted or heaved edge course. A failed edge restraint lets the border migrate outward. Without restraint, the whole field creeps and gaps open.
- Standing water or dark wet spots after rain. Bad slope or a clogged sub-base means water is trapped, which softens the base and speeds settlement. We see this on slopes facing the Spring Mountains where drainage was never graded right.
Any two of these together mean the base, not just the surface, needs attention. A single cracked unit is a small repair; a spreading field is a rebuild of the failed section.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what the work runs in Summerlin, and every number is the range we put in writing:

| Service | Installed Price Range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Paver patio installation | $3,500 – $11,000 |
| Driveway replacement | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
What drives the range: square footage, whether the existing base and edging can be reused or must be rebuilt, and the paver series you choose. A local section repair sits at the low end; a full driveway with new base and edge restraint sits at the high end. Parts and labor are itemized, so you see the paver cost and the labor cost separately, and none of it moves at the door. The completed work carries our 365-Day Done Right Promise: if the install doesn’t hold within a full year, we come back and correct it at no charge. We pull the permits the job requires and the site is cleaned and squared away at close, with your signed written guarantee in hand.
DIY or Call Us?
You can safely do a few things yourself. Sweep and top off joint sand, clear debris from the driveway edges so water drains, and lift a single loose paver by hand to see whether the base below is soft or solid. That check tells you whether you’re looking at a small fix or a failing field.
Where DIY goes wrong with pavers is the base. Digging out a section and resetting units without compacting a proper sub-base and reinstalling edge restraint gives you a repair that shifts again within a season, and in Summerlin’s heat-and-monsoon cycle that’s quick. Anything that changes the driveway’s structure, slope, or load path should go to a crew. Our technicians have up to 22 years of experience, are background-checked and uniformed, and we hand you a written price before work starts. Call (844) 588-0072 and a live person answers, any hour, to schedule your free estimate.
FAQs

A properly installed Barrette paver field lasts decades; the pavers themselves rarely fail. What fails first in Southern Nevada is the joint sand and the base, which is why the polymeric sand and edge restraint need attention every few years to keep the field tight.
Often yes. If the failure is confined to one section, the base under that section is solid, and the edge restraint holds, we repair the section and match the paver. If the field is rutting and spreading, only a rebuild of the affected area fixes it. We assess it and tell you which one you need in the written price.
A small section repair is usually a one-day job; a full driveway rebuild takes several days depending on square footage and base work. We schedule it and put the timeline in writing before we begin.
We identify your paver’s series, thickness, and color from a sample or the original submittal, then specify the matching unit and matched joint sand. We don’t keep parts on a truck; we source to your specific field so the repair blends in. Call (844) 588-0072 for an exact quote, and estimates are free.
Written by the team at Bradford Remodeling Co Summerlin, serving Summerlin and nearby areas.












