







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CGI Driveway & Pavers: The Summerlin Owner’s Guide
CGI-compatible paver driveways and patios installed in Summerlin typically run $7,000 – $18,000 for a paver driveway and $3,500 – $11,000 for a paver patio, with sealing at $250 – $700 and full driveway replacement at $5,000 – $14,000. We schedule those estimates within a few days, not weeks. Most Summerlin owners don’t discover a failing hardscape until a specific moment: a paver lifts and wobbles under the front tire, sand starts washing into the street after a monsoon, or a hairline crack in the driveway widens through one summer. In our climate the trigger is almost always the same – poor base compaction or a joint sand that dried out long before the surface showed it.

Bradford Remodeling Co Summerlin is an independent contractor and is not affiliated with CGI. We work with CGI’s documented hardscape line the same way we work with the other brands on our roster, including Belgard and Unilock pavers.
Key Takeaways
- Paver driveway installation in Summerlin: $7,000 – $18,000, priced in writing before any work starts.
- Patio installation: $3,500 – $11,000. Driveway replacement: $5,000 – $14,000. Sealing: $250 – $700.
- Most hardscape failure in Summerlin traces back to base prep and joint sand, not the pavers themselves.
- Every completed hardscape carries our 365-Day Done Right Promise in writing.
- Our technicians have up to 22 years of experience with paver and hardscape work.
Which CGI Models This Applies To

CGI’s driveway and paver line is manufactured to standard interlocking-paver dimensions, and that’s the first thing to verify before you order anything. Most CGI rectangular pavers, including their 60mm and 80mm profiles, run in the common 4×8-inch, 6×9-inch, and 12×12-inch module sizes, with some permeable and textured series varying slightly. Those variations matter: a 60mm paver swapped against an 80mm paver in the same field will sit proud or low no matter how carefully the installer sets the sand bed. If you’re replacing a section, the thickness has to match what’s already there, not just the face dimensions.
To identify what you have, pull up a paver at the edge of the failed section and look for a manufacturer stamp or lot markings on the side or underside. Measure both the face dimensions and the thickness with a tape. If the markings are gone or worn, a photo of the paver next to a ruler lets us match it to the current CGI series.
On the OEM-vs-aftermarket question: CGI’s own pavers are the safest match when you’re patching a small area and need a color and texture match to the existing field. For a full driveway or patio replacement, a documented equivalent from Belgard or Unilock – both brands we install – often gives you better long-term color consistency across a whole field, since the tolerances are tight and the manufacturer warranties are written. Either way, the material has to meet the same spec, and the base has to be built right underneath it.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CGI Driveway & Pavers Is Failing
The paver is rarely the thing that failed. These are the five symptoms we see most in Summerlin, and what each one actually tells you.
- Pavers rocking or sinking under a tire or foot traffic. That’s a base failure, not a paver failure – the compacted gravel layer underneath has settled or wasn’t compacted to depth in the first place. Left alone, the edge pavers shear and the joint sand migrates out.
- Sand washing out of the joints after a monsoon. Summerlin’s summer storms drive water hard and fast, and joints that have lost their polymeric sand have nothing holding the paver field together. Refilling the joints without fixing the drainage slope just moves the problem.
- Efflorescence or a white film on the paver face. That’s mineral salt drawn to the surface by moisture from below – often a sign the base is holding water rather than draining. It’s cosmetic, but it’s a warning.
- Widening cracks or a heaving edge. In Summerlin, ground movement and clay-heavy soil expansion under a shallow base push pavers up along the driveway edge. The crack widens each season.
- Color fading and surface roughness after a few summers. UV and dry heat wear down a sealant and the paver surface over time. This one is the easiest to catch early – a fresh seal every few years extends the field’s life considerably.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what Summerlin homeowners pay for hardscape work, installed. These ranges are what we put in writing before a single tool comes out, and the price doesn’t move at the door.
| Service | Installed Price Range |
|---|---|
| Paver Driveway Installation | $7,000 – $18,000 |
| Paver Patio Installation | $3,500 – $11,000 |
| Driveway Replacement | $5,000 – $14,000 |
| Concrete Driveway Installation | $4,500 – $12,000 |
| Asphalt Driveway Paving | $3,500 – $9,000 |
| Driveway Sealing | $250 – $700 |
What drives the range: square footage, the depth of base excavation required (Summerlin lots with poor drainage need deeper base work), paver selection, and whether the existing surface has to be torn out first. Our written quote breaks out the material, the base prep, the joint sand, and the labor, so you can see exactly where the money goes. Every completed hardscape is covered by the 365-Day Done Right Promise – if the work fails within a full year, we come back and correct it at no charge. The guarantee is in your hand when we close out the job, along with a clean site.
DIY or Call Us?
You can check a lot of this safely. Walk the driveway and feel for rocking pavers. Look at the joint sand after rain. Photo the paver edges where they’re heaving. Check whether water is pooling against the slab or draining off. Pull up a single loosened paver at the edge (not the middle) and look for the manufacturer stamp. That tells us the CGI series without any risk.
Where DIY goes wrong is the base. Pulling up and resetting a section without recompacting the gravel and re-establishing the slope just hides the failure for one season. And the work itself is physically demanding – a paver field weighs a lot, and a proper base compaction requires equipment most homeowners don’t own. The real risk here isn’t injury, it’s paying twice for the same job. A written quote costs you nothing, and it tells you whether the field needs a patch or a rebuild.
Call (844) 588-0072 for a free estimate. A live person answers, every time.
FAQs

A properly installed CGI paver driveway should hold up for 20 to 30 years in Summerlin, but the number depends more on base prep and joint maintenance than on the paver. Our dry heat and monsoon swings are hard on joint sand and sealant, so plan on resealing every three to five years – the $250 – $700 sealing range we quote above. Call (844) 588-0072 for an assessment on your specific driveway.
Often yes. A single section with rocking pavers can be lifted, recompacted, and reset at a fraction of replacement cost, provided the base underneath is sound and the field is otherwise intact. If the base has failed across more than a small patch, replacing the field is the honest answer. We’ll tell you which one you’re looking at. Call (844) 588-0072 for a free estimate.
A typical Summerlin paver driveway runs three to five working days from demolition to final joint sand and cleanup, depending on square footage and base depth. A patio is usually two to three days. We schedule the work in writing with a start date, and we don’t commit to a start date we can’t make.
We work from CGI’s documented product specifications and match your existing paver by thickness, face dimensions, and series before ordering, using the stamp on your existing pavers as the starting point. Where CGI’s current series can’t match an older field, we’ll price a documented equivalent from Belgard or Unilock and show you the spec side by side. Every material we order is traceable to a manufacturer spec and warranty. Our technicians have up to 22 years of experience doing exactly this.
We also work with KraftMaid, Cambria, and Silestone, among others, so the specs and the guarantees hold across every part of the job. Every project gets a written price before work begins and is covered by the 365-Day Done Right Promise. Call (844) 588-0072 for a free estimate on your Summerlin driveway or pavers.
Written by the team at Bradford Remodeling Co Summerlin, serving Summerlin and nearby areas.












