







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tamko Driveway & Pavers: The Summerlin Owner’s Guide
Installed Tamko paver driveways in Summerlin typically run $7,000 – $18,000, depending on square footage, base prep, and border detailing, and we can usually quote you a written price within a day of measuring. Tamko doesn’t make a dedicated driveway paver line the way it makes roofing and waterproofing products, so most failures we see here are installation-related rather than product-related: loose units, rutting, and sand washout traced back to thin base or skipped edge restraint. Owners usually notice it after a monsoon season, when a section of pavers shifts or a joint opens up and the whole driveway starts looking uneven.

Bradford Remodeling Co Summerlin is an independent contractor and isn’t affiliated with Tamko. What we do is install, repair, and replace paver driveways using Tamko-branded products where the spec calls for them, and tell you straight when a different product makes more sense for your lot.
Key Takeaways
- Most Summerlin paver failures we see are base and restraint problems, not product defects.
- Full paver driveway installs run $7,000 – $18,000; repairs and resealing cost far less.
- We give a written price before any work starts, and the finished job carries the 365-Day Done Right Promise.
Which Tamko Models This Applies To

Tamko’s paving and hardscape catalog is smaller than its roofing side, and the products most Summerlin homeowners have underfoot are the interlocking concrete paver lines sold through local masonry suppliers, plus Tamko’s waterproofing and surface treatments used around pavers and patio edges. The exact product name is usually molded into a small stamp on the paver face or printed on the pallet band from the original install. If you don’t have the original paperwork, we measure the unit – most driveway pavers run in nominal 4×8, 6×6, or 6×9 profiles with a thickness around 2 3/8 inches – and match the color family and texture to the surviving field.
The OEM-versus-aftermarket question matters here. Tamko’s own paver lines are still in production through regional distribution, so a true match is usually possible for current product. For older or discontinued profiles, a quality aftermarket paver in the same thickness and a close color blend is the practical answer, and we’ll show you samples so you’re not guessing. Some suppliers will quote a “close enough” paver that’s a quarter-inch thinner; that difference is exactly what causes lippage against your existing field, so we check thickness before we order anything.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tamko Driveway & Pavers Is Failing
- Rutting in the wheel paths. That’s usually a base that was compacted in one lift instead of two, common on Summerlin lots where the original builder left shallow base under the driveway. The paver is fine – the soil underneath moved.
- Loose or rocking units near the apron. Sand migration and missing edge restraint let pavers creep outward, especially where the driveway meets the street and takes the most turning load.
- Joint sand washing out after rain. Summerlin’s monsoon stretch drops a lot of water fast; if the joints aren’t refilled with polymeric sand, water gets under the surface and starts working on the base.
- Efflorescence or white haze that won’t scrub off. Mineral salts wicking up through the paver, usually a sign of trapped moisture underneath rather than a dirty surface.
- Sun-faded color and surface chalking. Summerlin sits at higher elevation with intense UV, and unpigmented pavers can bleach over time. Fading alone is cosmetic; fading with surface spalling means the unit itself is breaking down.
We see one pattern repeat here: driveways laid on a single compacted lift of base tend to show rutting within a few seasons, while the same pavers on a properly built two-lift base with edge restraint hold up for decades. The paver isn’t the variable – the prep is.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what the work runs in Summerlin, installed:
| Scope | Installed range |
|---|---|
| Paver driveway installation (Tamko-compatible pavers) | $7,000 – $18,000 |
| Driveway replacement (remove old, rebuild base, reinstall) | $5,000 – $14,000 |
| Concrete driveway installation | $4,500 – $12,000 |
| Asphalt driveway paving | $3,500 – $9,000 |
| Driveway sealing | $250 – $700 |
The range moves on square footage, how much existing base has to be excavated and rebuilt, edge restraint type, and whether you want a border course or a decorative pattern. Every quote is written line by line – pavers, base material, compaction, polymeric sand, restraint, haul-away – so you can see where the money goes. No numbers move at the door: the price we write is the price you pay, unless you approve a change in writing. The finished work is covered by the 365-Day Done Right Promise, which means if a repair or install fails within a year, we come back and correct it at no charge.
DIY or Call Us?
You can safely check a few things yourself. Fill a bucket of water on a joint and watch whether it drains or puddles, run a level across the surface to confirm the slope, and pull up one loose paver to look at the sand bed underneath. That tells you whether you’re dealing with a surface issue or a base problem.
Where DIY goes wrong is the base. Rebuilding a driveway properly means excavating to depth, laying and compacting aggregate in lifts, setting edge restraint, and screening the bedding sand flat – all before the first paver goes down. Working a full driveway by hand with a plate compactor is hard, slow, and easy to get subtly wrong in a way that shows up two summers later. We don’t advise tackling a full driveway replacement yourself; a small repair to a handful of loose units is reasonable, a full rebuild isn’t.
Call (844) 588-0072 for a free written estimate. A live person answers, day or night.
FAQs

A properly built paver driveway on a two-lift compacted base with edge restraint lasts 25 to 30 years or more in Summerlin’s climate, with joint sand topped up every few years. Lifespan is set by the base and by how often the joints are maintained – not by the paver itself.
Often yes. Isolated rocking or sunken sections can be lifted, re-bedded, and re-sanded without tearing out the whole field, and that’s usually the right call when the base under most of the driveway is sound. A full replacement makes sense when rutting or base failure runs across the whole surface.
A repair to a small section is usually a one-day job. A full driveway replacement typically takes three to six working days, depending on square footage, excavation, and how much base has to be rebuilt before installation starts. We give you a written schedule with your quote.
We order through local masonry suppliers and match the product by name, stamp, or physical measurement if the original paperwork is gone. If the exact Tamko profile is discontinued, we bring you physically matched samples in the same thickness so you can see the blend before anything is ordered.
Call (844) 588-0072 to schedule your free estimate. We’ll measure the job, give you a written price in plain terms, tell you exactly what the 365-Day Done Right Promise covers, and leave the site clean when we’re done. We also work with KraftMaid, Cambria, and Silestone products on the interior side of the house.
Written by the team at Bradford Remodeling Co Summerlin, serving Summerlin and nearby areas.












