







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Atlas Driveway & Pavers: The Summerlin Owner’s Guide
We install and repair Atlas driveway and paver systems throughout Summerlin, and the installed cost for a full paver driveway runs $7,000 – $18,000, while a paver patio lands between $3,500 and $11,000. Smaller corrections – resetting a settled run, replacing cracked units, re-laying a failed edge course – are quoted as a written line item before any work starts, so you know the figure before a single paver moves. Most Summerlin owners notice the problem the same way: a low spot that holds water after the irrigation runs, a paver that rocks underfoot near the driveway apron, or sand washing out of the joints faster every year.

Atlas is a paver and hardscape manufacturer, and its systems show up on driveways, walkways, and patios across the northwest valley. The failures we get called about aren’t usually the paver itself. They’re the layers underneath it and the edge restraint holding the field in place. Summerlin’s soil, sun, and irrigation schedule put real stress on both.
Key Takeaways
- Installed Atlas paver driveways in Summerlin: $7,000 – $18,000; patios: $3,500 – $11,000.
- Most “paver failures” are base, bedding, or edge-restraint failures, not the block.
- We quote a written price before work begins, and every completed project carries the 365-Day Done Right Promise.
Which Atlas Models This Applies To

Atlas makes pavers in several profiles and thicknesses, and getting the match right matters more than people expect. Standard driveway pavers run about 2 3/8 inches thick; thinner 1 5/8-inch units are patio and walkway grade and will crack under vehicle loads. If you’re matching an existing field, you need the profile name, the color blend, and the thickness – not just “gray Atlas paver.”
Here’s where Summerlin owners get burned. Atlas has updated color blends over the years, and a “Charcoal” or “Sierra” from an older production run won’t match the current blend sitting in a pallet at the yard. Dye lots shift. If you’re patching a section rather than replacing the field, the honest answer is often that a close match is possible but not a perfect one, and we’ll tell you that before you spend the money.
To identify your system, check three places. The original construction paperwork or HOA submittal, if you have it. The underside of a loose paver, which sometimes carries a stamp. And the actual measurements – length, width, thickness, and joint width. We also run a straightedge and a level across the field, because base condition determines whether a patch will hold or telegraph through in a season.
On OEM versus aftermarket: Atlas pavers set the visual standard, but the base aggregate, bedding sand, joint sand, and edge restraint are what make the system last. Those come from different suppliers and are where quality gets decided. We work from a documented roster of name-brand materials – Belgard and Unilock among the hardscape lines – so specifications are traceable if something ever needs a warranty claim. To be clear: Bradford Remodeling Co Summerlin is an independent service provider and is not affiliated with Atlas.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Atlas Driveway & Pavers Is Failing
Five symptoms come up again and again on Summerlin properties, and each points to a specific cause underneath the surface.
- Pavers rocking or shifting underfoot. The bedding sand has migrated or compacted unevenly, usually from water getting under the field. Ignore it and the paver edges start chipping against their neighbors.
- Low spots holding water after rain or irrigation. A settling base or a drainage grade that was never pitched correctly. Standing water in our sun-and-freeze-thaw cycle works loose the joint sand and speeds up the whole failure.
- Sand washing out of the joints repeatedly. Often an edge restraint problem – the perimeter gave way and the field is spreading outward. Re-sanding without fixing the edge is a temporary fix that fails again within a season.
- Weed growth in the joints and along the edges. Wide or eroded joints letting seed and water in. Polymeric joint sand resists this far better than plain sand, but it only works if the joints are the right width.
- Cracked or spalled pavers, usually near the driveway apron. Vehicle loads on patio-grade thickness, or a base that wasn’t compacted to spec. In Summerlin we regularly see this where a lighter unit was used on a driveway because it matched a color.
One local reality worth naming: Summerlin’s caliche-heavy soil drains poorly in spots, and irrigation overspray hitting a driveway edge is a common accelerant. A system that looks fine in a wet spring can fail fast through a dry summer.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Installed pricing in Summerlin runs $7,000 – $18,000 for a paver driveway and $3,500 – $11,000 for a paver patio. A full driveway replacement, where the old surface comes out and the base is rebuilt, runs $5,000 – $14,000. Sealing a sound existing surface is $250 – $700 – worth doing, but only after any base or edge problems are corrected, or you’re sealing a failure in place.
What drives the range: square footage, thickness and profile of the paver, how much base has to be excavated and rebuilt, the condition of the edge restraint, and access. A tight side yard or a gate the crew has to hand-carry materials through adds labor.
| Scope | Installed Range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Paver patio installation | $3,500 – $11,000 |
| Driveway replacement (remove & rebuild base) | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
Every price is written before work begins, with parts and labor broken out as line items. No numbers that move at the door. Completed work is covered by the 365-Day Done Right Promise: if it fails within a year, we come back and correct it at no charge. The crew is background-checked and uniformed, and a live person answers the phone 24/7.
DIY or Call Us?
There’s a safe middle ground here. You can pull a loose paver and look underneath, check whether the edge restraint is intact, run a level across the field, and see where water is pooling. That tells you a lot about what’s actually failing.
Where DIY goes wrong: re-laying pavers over a base that was never properly compacted, or re-sanding joints while the edge has failed. Both look fixed for a month and then fail again, and you’ve spent the money twice. Excavation and base compaction are also real physical work, and a badly rebuilt base under a driveway load is a do-over. If the field is settled or the edge has given way, it’s a base job, not a paver job – and that’s where we come in. All work is quoted in writing before it starts, and our technicians have up to 22 years of experience in hardscape construction.
Call (844) 588-0072 for a free estimate. We’ll tell you straight whether you need a repair, a rebuild, or just a re-sand and seal.
FAQs

How long do Atlas pavers last in Summerlin? A properly installed Atlas paver system holds up for decades – the pavers themselves often outlast the base. In Summerlin’s sun and heat, the base, bedding sand, joint sand, and edge restraint are what need attention, usually somewhere in the 10-to-15-year range if the original install was done right. Call (844) 588-0072 for an assessment.
Can it be repaired instead of replaced? Often, yes. Resetting a settled run, replacing cracked units, re-establishing the edge restraint, and re-sanding can fix a lot without touching the whole field. Whether that’s the right call comes down to how much of the base is compromised – we’ll measure it and give you the straight answer. Estimates are free: (844) 588-0072.
How long does the swap take? A localized repair is usually a single day. A full driveway rebuild is typically two to four days in Summerlin, depending on square footage, base depth, and access. The schedule is written into the quote before work starts. Call (844) 588-0072 to get your timeline.
How do you source the part? We source Atlas pavers and compatible components through hardscape suppliers with documented manufacturer specs and warranties, and we match profile, thickness, color blend, and dye lot as closely as the current production allows. We’ll tell you upfront if an exact match to an older run isn’t possible. Call (844) 588-0072 for a free estimate.
If you’re also planning interior work, we install KraftMaid and Wellborn cabinetry and set Cambria and Silestone surfaces – same written-price approach on every job.
Written by the team at Bradford Remodeling Co Summerlin, serving Summerlin and nearby areas.












