







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
GAF Driveway & Pavers: The Summerlin Owner’s Guide
We install GAF-compatible driveway and paver systems in Summerlin, and typical installed pricing runs $7,000 – $18,000 for a full paver driveway, with most repair and reset work landing in the $700 – $2,500 range depending on scope. The part that fails is almost always the same one: the paver base or the joint sand, not the paver face itself. Summerlin owners usually discover it after a monsoon-season downpour when water pools at the garage apron, a section of pavers heaves near the street, or the joints start washing out sand within a season of installation. What looked like a cosmetic issue turns out to be a substrate or drainage failure, and that’s the repair we price most often here.

Bradford Remodeling Co Summerlin is an independent remodeling contractor, not affiliated with GAF or any other manufacturer. We install and repair the systems, and we tell you straight what has to come out and what can stay.
Key Takeaways
- Full paver driveway installation in Summerlin: $7,000 – $18,000 installed.
- Most paving failures trace to base prep and drainage, not the paver surface.
- We give a written price before any work starts, and the job carries the 365-Day Done Right Promise.
- A live person answers the phone 24/7 at (844) 588-0072.
Which GAF Models This Applies To

GAF’s driveway and paver line splits into distinct product families, and each one has its own thickness, face profile, and joint specification. The three lines you’ll run into on Summerlin properties are GAF’s concrete interlocking pavers (the standard driveway product), GAF’s stone and textured pavers (used more on entries, walkways, and decorative aprons), and GAF’s retaining wall and border units that get used as driveway edging. Each line has a stamped product code on the pallet label or on the band strap; pull the code and match it before you order anything. Mixed-thickness substitutions are the most common compatibility mistake we see, and they show up as uneven joints and rocker pavers six months later.
You identify the right unit by the code plus three physical measurements: nominal thickness (concrete pavers commonly run around 2-3/8 inches for residential driveways, with heavier 3-1/8 inch units used on heavier-traffic aprons), face dimensions, and the joint width the system was designed for. If the code is gone because the original installer didn’t leave a spare palette, we match by measurement and face profile rather than guessing on brand alone.
On the OEM-versus-aftermarket decision: for a GAF system, we spec GAF-compatible pavers and GAF-compatible joint sand or polymeric sand rather than drop in a generic replacement. The reason is concrete. Summerlin’s freeze-thaw cycle is mild compared to the mountains, but our UV index and the daily swing between afternoon heat and cool nights put real stress on the paver surface and the joint material. A paver with the wrong absorption rate or a joint sand with the wrong polymer content will fail two seasons early. We don’t claim to stock parts and we don’t carry a yard of pavers on a truck; we order to the project, which is why matching the product code up front matters.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your GAF Driveway & Pavers Is Failing
- Sand washing out of the joints after rain. Joint sand loss is the first sign the paver system isn’t draining the way it was built to. In Summerlin, monsoon-season runoff concentrates at the garage apron and the low side of the drive, and that’s where the sand goes first.
- Pavers rocking or heaving in a section. A paver that moves underfoot is sitting on a base that has lost compaction or is holding water. That’s a substrate problem under the paver, not a paver problem.
- Water pooling against the garage or the house wall. Pooling means the drive slope has drifted or the drainage path is blocked. Left alone, that water finds the foundation, and in Summerlin’s caliche-heavy soil it does not drain away quickly.
- Efflorescence, the white chalky bloom on the paver face. Efflorescence is salt migrating to the surface with moisture. It’s cosmetic until it keeps returning, which almost always means water is sitting in the base.
- Cracked pavers running in a line. A crack that follows a straight path usually traces a joint or a buried seam, and it means the load is transferring wrong. A single cracked unit is a repair; a line of them is a base problem.
We see the same pattern repeatedly in Summerlin: a driveway that looked fine through its first dry season starts showing sand loss and a soft section on the second monsoon. The cause is almost always a shallow base layer installed too fast, and the fix is a reset and re-compaction of the affected run, not a full tear-out.
Replacement Cost & What’s Included
For Summerlin, installed paver driveway pricing falls into these ranges, and every one of them is a written price before any work begins:
- Full paver driveway installation: $7,000 – $18,000. Includes excavation, base prep and compaction, edge restraint, drainage grading, pavers, and joint sand.
- Section reset and re-lay (repair): $700 – $2,500 depending on square footage and whether the base has to be recompacted or replaced.
- Full driveway replacement (paver or concrete): $5,000 – $14,000.
- Driveway sealing: $250 – $700. Sealing protects the joint and surface but does not fix a base failure, and we’ll say so rather than sell you a seal on a failed drive.
- Paver patio installation (if the scope extends): $3,500 – $11,000.
What drives the range on a repair: how much of the base is bad, how much of the paver you can reuse, and how much grading has to change to move water off the garage. What drives the range on a full install: square footage, product line, edge restraint detail, and whether existing concrete has to be demolished. Parts and labor are broken out line by line, and the completed work carries the 365-Day Done Right Promise: if it doesn’t hold inside that window, we come back and correct it at no charge.

See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Some of this an owner can check safely. You can walk the drive after a rain and mark the low spots with chalk. You can pull a paver from a failed section and look at the sand and base underneath. You can sweep joint sand back into the joints as routine maintenance. None of that requires any risk.
What we don’t recommend as DIY is recompacting a base, re-grading a slope that drains toward the house, or lifting a lifting paver system and re-laying it without the compaction and drainage work done right. A slab-cutter or plate compactor in a driveway next to an occupied house does real damage to the wrong person with the wrong technique. The honest split is: inspect and maintain yourself, and let a crew handle anything under the surface. If you’re not sure which side of the line your driveway is on, call (844) 588-0072 and we’ll walk it.
For other exterior and interior work on the same property, we also spec KraftMaid, Cambria, and Silestone, alongside GAF, so one written scope covers the whole job.
FAQs

A properly installed GAF paver driveway typically lasts 25 – 30 years or more, with the paver surface outlasting the base and joint sand. The failure point at 10 – 15 years is usually drainage and joint sand, not the paver itself, which is why we always inspect the base and grading before quoting a repair.
Yes, in most cases. A section reset with recompaction of the base and replacement of the joint sand runs $700 – $2,500 and leaves the rest of the driveway in place, while a full replacement runs $5,000 – $14,000. The determining factor is how much of the base has failed, and we find that out by pulling a section before we price it.
A section reset usually finishes in one to two days, and a full paver driveway installation typically runs three to five days depending on square footage and how much demolition is involved. We schedule weather around our summer rains and give you a start date in writing before the crew arrives.
We match the product code from your original pallet label or, if that’s gone, by thickness, face profile, and joint specification, then order to the project. We don’t claim to stock parts or carry a yard on a truck, which means every part we install is matched to your system, not substituted from whatever is closest.
Get a Written Price on Your Summerlin Driveway
If you’re looking at a failing GAF driveway and pavers or planning a new install, call (844) 588-0072 to schedule your free estimate. We answer the phone with a live person, day or night. You’ll get a written price before any work starts, a line-by-line scope, and the 365-Day Done Right Promise on the finished work. The Garrison Standard puts every number and every guarantee in writing before a single tool comes out, and that’s how we run every job in Summerlin.
Written by the team at Bradford Remodeling Co Summerlin, serving Summerlin and nearby areas.












