







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Toto Bathroom Remodeling: The Summerlin Owner’s Guide
Toto bathroom remodeling in Summerlin typically runs $9,000 – $28,000 installed, and we handle it on a scheduled basis with a written price before any work starts. Most Summerlin owners we meet didn’t set out to remodel. They went looking for one failed part on a Toto toilet, found a discontinued fill valve or a cracked seat, and realized the whole room was due. The symptoms show up the same way again and again: a toilet that runs for 30 seconds after every flush, water pooling at the base, a seat that rocks, a tank that sweats through the dry months. This guide is for that owner. We’re Bradford Remodeling Co Summerlin, an independent contractor and not affiliated with Toto, and we work on Toto-equipped bathrooms across the valley. Non-Toto brands too: KraftMaid, Cambria, Silestone.

Which Toto Models This Applies To

Toto’s lineup splits by flush platform, and the platform is what decides which parts fit. The Drake and Eco Drake (CST7 series) are gravity toilets with a standard 3-inch flush valve and a fairly conventional fill valve. The Ultramax and Ultramax II are one-piece units, which changes how you access the tank internals. Washlet seats (S550e, C5, K300) are a separate animal entirely: they carry electronics, a water heater, and a bidet wand assembly that has no equivalent on a plain toilet. The Neorest line is fully integrated and almost never a parts swap; those come out and get replaced or serviced by a Toto-authorized technician.
How to identify what you have: pull the tank lid and look at the stamped model number on the inside back wall, usually a CST or MS prefix. The serial tag behind the bowl at the floor line confirms the production run. Measure the rough-in (wall to the center of the closet bolts): most Summerlin homes are 12-inch, but some mid-2000s builds in The Ridges and Red Rock Country Club use 10-inch, and ordering the wrong one means the toilet won’t sit flush. OEM Toto parts cost more than aftermarket kits and fit cleanly. Aftermarket fill valves and flappers from Fluidmaster or Korky are common substitutes and work for a while, but on Toto one-piece tanks they can hang up on the flush tower. On a washlet, always go OEM; no aftermarket seat electronics match Toto’s control board.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Toto Bathroom Remodeling Is Failing
These are the failure points we see most often when a Summerlin homeowner calls about a Toto that isn’t acting right:
- The toilet runs long after the flush. Usually a tired fill valve or a flapper that no longer seals against the rim. Common once a toilet passes the 8 – 10 year mark, and accelerated in Summerlin’s hard water, which leaves scale on the flapper and valve seat.
- Water pooling at the base or a wobble. The wax ring has failed, or the flange is cracked. Left alone, it wicks into the subfloor and damages the flooring around the toilet, which turns a $200 fix into a floor repair.
- A rocking seat. Elongated Toto seats use a specific bolt spacing. A universal seat bolted on won’t sit flat, and the constant rocking cracks the seat hinge and can stress the bowl ears over time.
- The washlet beeps or won’t heat water. On S550e and C5 units, a dead heater or a fouled water inlet screen is behind most of these. The screen clogs faster in Summerlin because the feed water carries mineral load.
- A visible crack in the tank or bowl. Nevada’s hot, dry summers and cool winter nights cycle the porcelain, and a hairline crack can open up. A cracked tank is a stop-use situation, not a repair.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

When the failed part is the excuse to remodel, the whole-room range in Summerlin is $9,000 – $28,000 installed, and we put that number in writing before we touch a tool. That covers the range most Toto owners land in. What moves you up or down inside that range:
- A basic toilet-and-vanity refresh with the same footprint sits at the low end.
- Replacing or adding a Toto washlet, moving fixtures, or reconfiguring the shower pushes toward the middle.
- A full rebuild with new tile, a walk-in shower conversion, and updated plumbing rough-in goes to the top of the range.
If only the toilet needs attention, a single toilet replacement inside an existing bathroom runs $300 – $1,200 installed, and a washlet seat swap runs $150 – $900 depending on the model and whether the outlet location needs adjustment. Cabinet-level work (a new vanity or linen storage) is quoted separately and pulls in our cabinetry lines. Every price is line-itemed, part and labor, so you can see what the Toto part costs versus the installation. Any completed work carries the 365-Day Done Right Promise: if it fails within a year, we come back and correct it at no charge.
DIY or Call Us?
Here’s the honest split. A homeowner can safely tighten a loose seat bolt, check the tank water level against the fill line, and swap a flapper on a gravity Drake with the water shut off. Those are low-risk and low-cost. What goes wrong in DIY on Toto equipment: yanking a one-piece tank off its gasket without supporting it cracks the bowl; cross-threading a supply line floods the cabinet under the vanity; and on a washlet, a homeowner unplugging and reconnecting a unit without checking the GFCI outlet and the ground can create a real electrical hazard. Water and electricity share that wet environment, so if the job involves the washlet’s wiring or a fixture relocation, have it done by a trained professional. Call us at (844) 588-0072 and we’ll tell you straight whether it’s a five-minute fix or a job to schedule.
FAQs

A Toto fill valve and flapper typically last 8 – 12 years under normal use, and Summerlin’s hard water shaves that toward the lower end because mineral scale builds on rubber parts faster. A Toto washlet’s internal heater and bidet wand regularly see 7 – 10 years before service. If yours is approaching either window, it’s worth having us look before a part fails. Call (844) 588-0072 for a free estimate.
Fill valves, flappers, seat hinges, and supply lines are all repairable or replaceable on their own, and that’s often the right move. The parts that don’t repair are a cracked tank or bowl and, on a washlet, a failed control board, which we replace rather than rebuild. We’ll tell you which category you’re in before quoting. Call (844) 588-0072 for an exact answer.
A single Toto toilet or washlet seat swap usually takes 1 – 3 hours on site; a full bathroom remodel in Summerlin runs 2 – 4 weeks depending on scope and inspection scheduling. We give you the schedule in writing with the price. Call (844) 588-0072 to get your estimate scheduled.
We order on-demand. We do not keep parts on a truck or in stock, because a wrong-fit part on a shelf is a wasted trip. We confirm your Toto model with the tank stamp and rough-in measurement, order the OEM or approved equivalent from a documented supply source, and bring it to the install. That traceability is part of how we work. Call (844) 588-0072 to start.
When you’re ready to price it, call (844) 588-0072 for a free estimate. We’ll give you a written price range for your Summerlin bathroom, a line-item breakdown of the Toto part and the labor, and a schedule before any work starts. Background-checked, uniformed technicians arrive on the day we say. A live person answers the phone 24/7. Our technicians have up to 22 years of experience, and every finished job leaves with a clean site, a documented scope, and the 365-Day Done Right Promise in your hand.
Written by the team at Bradford Remodeling Co Summerlin, serving Summerlin and nearby areas.












